• Speed Range: 50 – 450 fpm (15 – 137 m/min) infinitely variable with an inverter drive.
• Front Mounted Speed Control: Allows blade speed to be adjusted from operator’s control station.
• Feed Pressure: Infinitely variable with control on operator’s panel and Automatic Column Return. Column feed is mechanical with Marvel clutch power feed.
• T-Slotted Work Table: Work area 24.25” x 33” (616 mm x 838 mm); Table height 34.5” (876 mm)
• Blade Break/Stall Detection: Standard equipment, shuts off the machine in the event of blade breaking or stalling.
• Wheel Diameter: 19” (482 mm), cast iron wheels.
• Quick-Action Vise: Jaws can be shifted to either right or left side of the blade. Jaws are 6” (152 mm) high, 12” (305 mm) wide.
• Automatic Stops: Adjustable stops can be pre-set to stop advance and return of blade, and also to stop the motor at any location within the 18” (457 mm) travel of the blade.
• Flushing Hose: Washes chips from hard to get at places reducing clean-up time.
• Power Chip Brush: Together with blade wipers and flood coolant deep blade teeth free of chips.
| CAPACITY: 90° | 18″ x 22″ |
|---|---|
| CAPACITY: 45° | 18″ x 12.75″ |
| SPEED RANGE | 50-450 fpm infinitely variable speed drive system. |
| BLADE | 14′ 6″ Long x 1″ Wide x .035″ Thick. One Welded-Edge Band Blade is furnished with each machine. |
| MOTORS | Main; 5 H.P., 1800 RPM, totally enclosed fan cooled. Coolant Pump; 1/8 H.P. enclosed motor-built-in integrally. |
| CAPACITY: 90° | 18″ x 22″ |
|---|---|
| CAPACITY: 45° | 18″ x 12.75″ |
| SPEED RANGE | 50-450 fpm infinitely variable speed drive system. |
| BLADE | 14′ 6″ Long x 1″ Wide x .035″ Thick. One Welded-Edge Band Blade is furnished with each machine. |
| MOTORS | Main; 5 H.P., 1800 RPM, totally enclosed fan cooled. Coolant Pump; 1/8 H.P. enclosed motor-built-in integrally. |
IEC fused disconnect switch and magnetic motor starters, with overload and low-voltage protection. The disconnect is NFPA79 compliant. DC Power supply provides low voltage control (24 Volts) to all push buttons at operator’s control panel and machine lighting circuits. PLC control and components mounted in moisture proof NEMA 12 compartment. Electrical Panel is UL labeled.
Marvel’s patent pending Quick Change Column is standard on all machines. Allows column to be set either upright or at a 3° forward cant. (8-MARK III model only) *8-Mark II model is available in either 90º or 3º cant. Column travels on recirculating linear ball bearing rails.
Column and blade tilt right and left of vertical; work always stationary. Manual tilt standard with Sure-Lock and Built-in protractor. Electric Power tilts optional.
Built-In with flood system, available with added optional drop lubrication system (Option Codes ML1 & ML2). Controlled by on-off selector switch at operator’s station. Tank capacity 21 gallons (79 liters).
Column 6” longer than standard, providing the increased vertical capacity to 28” at the vertical position. *Includes option code 8/M3M powered tilt. (8-MARK III model only)
