• Speed Range: 65 – 325 fpm infinitely variable with an inverter drive. The broad speed range allows for optimum cutting of a large spectrum of materials. An electric tachometer assures accurate speed setting.
• Blade Tension: Hydraulically controlled tension (30,000 psi) provides consistent square cutting accuracy. The motion detector will shut the machine off should the blade break or stall.
•Hydraulic Down Feed: Feed rate and down pressure can be controlled independently for fast, accurate cutting. Setup is made easy through the color-coded dial allowing the operator to select the optimum setting for the type of material being cut. Both settings are made at the operator’s station.
• Piece Counter: The machine will stop the automatic cycle when a predetermined number of cuts have been reached.
• Blade Guides: The combination of the roller bearing and carbide blade guides reduce heat and blade stress providing longer blade life and accuracies of ± .002 per inch of cut material.
• Work Light: Positioned directly over the work area to provide better illumination of the cutting area, the work light can be turned on and off independently from the operator’s control panel.
• Full Stroking Hydraulic Vise Jaws: Holding the work piece on both sides of the blade reduces blade vibration, providing more accurate cuts and longer blade life. Rear Vise: The rear vise jaw floats hydraulically to accommodate crooked stock assuring straight, accurate cuts.
• Chip Brush: Powered from the main drive shaft of the saw, the brush changes speed along with the blade to assure that chips are being removed from each gullet of the blade, improving cutting performance and blade life.
• Fast Approach: Work height is automatically set allowing the head to rise just enough to clear the work piece, reducing cycle time and allowing for faster cutting performance.
• Pass Line Height: 32.625”
| CAPACITY: 90° | 14-1/2″ x 24″, Round 14-1/2″ |
|---|---|
| CAPACITY: 45° | 14-1/2″ x 16-1/2″, Round 14-1/2″ |
| SPEED RANGE | 65-325 fpm infinitely variable speed drive system. |
| BLADE | 16′ 1″ Long x 1-1/4″ Wide x .042″ Thick. One Welded-Edge Band Blade is furnished with each machine. |
| MOTORS | Main; 5 H.P., 1800 RPM, totally enclosed fan cooled. Coolant Pump; 1/8 H.P. enclosed motor-built-in integrally. Hydraulic Pump Motor: 1 H.P. All motors are dual voltage, 230/460 volt, 3 ph. 60 Hz. |
Feed rate and down pressure can be controlled independently for fast, accurate cutting. Setup is made easy through the color-coded dial allowing the operator to select the optimum setting for the type of material being cut. Both settings are made at the operator’s station.
Length settings of 0 – 23.625” are accomplished with a hand-wheel and readout a digital counter. The shuttle comes to positive stops at both ends of the index, assuring cutoff length accuracy, reducing material loss. Repeatability is ± .005 per index. Up to 9 cycles are possible through the multi-index system.
Manually positioned up to 60° Left and 45° right, equipped with degree scale.
The nesting fixtures for vertical clamping are designed for high-production multiple cutting. Vertically mounted hydraulic clamps located on each vise jaw apply downward pressure to hold multiple bar work or structural shapes.
Heavy duty free standing tables in either feed or discharge. Available in 3 and 6 meter options.
