CONTROLS
An Independent Electric Cabinet and Control Panel allow the operator to position the controls for optimum viewing of the cutting area. A PLC controls all electrical and hydraulic functions.
Marvel
PA 2743S/1/1.5/3
PA 2743S/1/1.5/3
CAPACITY: 27.5” X 43”, 28″ Round
FINANCING AVAILABLE!
two way miter cutting, brought to you by the PA 2743S/1/1.5/3
• Speed Range: 50 – 325 fpm infinitely variable with a frequency inverter system and a heavy duty Worm Gear Transmission. The broad speed range allows for optimum cutting of a large spectrum of materials. An Electric Tachometer assures accurate speed settings.
• Blade Guides: A combination of roller bearing and hydraulically actuated carbide blade guides assures the blade is held taut for fast, accurate cuts.. The cast iron Movable Guide Arm is positioned through a Hydraulic Cylinder, then is Hydraulically Locked in position.
• Blade Tension: Hydraulically controlled tension (35,000 psi) provides consistent square cutting accuracy. The Motion Detector will shut the machine off should a blade break or stall. Blade Wheel Diameter is 34.625” to provide maximum blade life.
• Blade Break/Stall Detection: Standard equipment, shuts off the machine in the event of blade breaking or stalling.
• Chip Brush: An Independent Motor drives the Blade Brush to assure complete removal of chips from each gullet of the blade assuring optimum cutting performance and enhanced blade life.
• Vise Jaws: Full Stroking Vise Jaws and a Vertical Clamp Devise assure the work piece is secure and eliminates excessive vibration during the cut providing better blade life and cleaner cuts. Minimum Clamping Capacity is 16.125”.
• Machine Floor Space: 88-1/2” H x 165-3/8” W x 74-5/8” D
• Table Height: 37″
PA 2743S/1/1.5/3
| CAPACITY: 90° | 27-1/2″ x 43″, 28″ Round |
|---|---|
| CAPACITY: 45° | 26-3/4″ x 27-1/2″. 26-3/4″ Round |
| SPEED RANGE | 50-325 fpm infinitely variable speed drive system. |
| BLADE | 31′ 6″ Long x 2″ Wide x .063″ Thick. |
| MOTORS | Main; 10 H.P., 1800 RPM, totally enclosed fan cooled. Hydraulic Pump Motor: 3 H.P., Oil Mist Coolant System: 1/4 H.P., Wire Brush Motor: 1/8 H.P., Table Rotation: 1/2 H.P. |
PRODUCT SPECIFICATIONS
FAST APPROACH
Work height is automatically set allowing the head to raise just enough to clear the work piece, reducing cycle time and allowing for faster cutting performance.
SAW FRAME
The saw frame is canted at an 8° angle for faster cutting of structural and other flat materials. The saw base Swivels to 45° one direction and 60° the other, for miter cutting. A ½ hp motor turns the machine base and the degree of angle is read out on a LED DISPLAY. The Heavy Duty Saw Frame rides up and down a Linear Way Guide System.
HYDRAULIC DOWN FEED
Feed rate and pressure can be controlled independently for fast, accurate cutting. Setup is made easy through the color coded dial allowing the operator to select the best setting for the type of material being cut.
